HiPSI
11-30-2006, 02:06 PM
got tired of listening to turndowns under the car coupled with not being able to pull in or out of my driveay without massive scraping involved so i decided to order up some piping and fire up the welder. the previous setup was straight 2.5" pipes to some knockoff flowmasters and turndowns right at the rear swaybar. new setup is twin 2.5" into single 3" and out through a cheap ebay muffler. it runs up nice and high under the car so no more scrapage issues and the sound is more vette than camaro now.
http://img329.imageshack.us/img329/2537/1002836lk8.jpg
http://img214.imageshack.us/img214/5919/1002837dn7.jpg
http://img169.imageshack.us/img169/7316/1002838vm4.jpg
http://img169.imageshack.us/img169/9158/1002839dr2.jpg
i will be rebuilding the setup later once i can build some headers for it but for now this will work just fine. with the old setup it made 332/326 with about 120 miles on the new motor, i'll probably be heading back to see if the exhaust + breakin miles have done any good along with some tuning with HPT to get the most out of it. shooting for about 360-365whp with tuning time :D.
http://img329.imageshack.us/img329/2537/1002836lk8.jpg
http://img214.imageshack.us/img214/5919/1002837dn7.jpg
http://img169.imageshack.us/img169/7316/1002838vm4.jpg
http://img169.imageshack.us/img169/9158/1002839dr2.jpg
i will be rebuilding the setup later once i can build some headers for it but for now this will work just fine. with the old setup it made 332/326 with about 120 miles on the new motor, i'll probably be heading back to see if the exhaust + breakin miles have done any good along with some tuning with HPT to get the most out of it. shooting for about 360-365whp with tuning time :D.