PDA

View Full Version : 93 240sx help


santacruz77
10-25-2006, 12:57 PM
i have a 93 240sx coupe
ok today when i started it up today it just stoped going into gears like it wouldnt go into and really but befor today it shifted awsome the clutch gripped awsome but the throw out bearing was bad and it never grinded wat should i do ?
§treet_§peed
10-25-2006, 10:55 PM
go have your tranny looked at...cause it sounds like you fucked it up to where it will not let it take pressure of to allow you to change the gears...but the way you made your statment confusses me on exactly what you mean...
SE-Rious1
10-25-2006, 10:59 PM
check the clutch fully make sure it is ingageing and does it not go into ger when cars not running ?
HiPSI
10-26-2006, 09:46 AM
more than likely leaking slave cylinder not letting the clutch disengage. check the fluid in the clutch master cylinder to see if it's low and if it is look under the right side of the car on the bellhousing to see the slave itself.
bluuuurr
10-26-2006, 02:43 PM
hold the clutch down in neutral, hold the motor at about 3k rpm, and try to put the car into every forward gear.. if you can't, your pressure plate is not releasing.. which means, no pressure (slave cylinder)
TheSnail
10-26-2006, 02:45 PM
You should sell it to me.
§treet_§peed
10-26-2006, 04:00 PM
haha or me...:D
Z U L8R
10-26-2006, 04:43 PM
i concur with hipsi, clutch slave most likely
santacruz77
11-06-2006, 08:55 PM
its fixed now and sell what to yall
Neejay
11-06-2006, 09:52 PM
its fixed now and sell what to yall
The car :)
santacruz77
11-07-2006, 10:34 AM
how much you wanna give me for pm if your really want it
Flip
11-07-2006, 10:38 AM
what did the problem end up being?
santacruz77
11-07-2006, 04:22 PM
ugh i just put a new clutch and presure plate in and it fixed it all good as new
§treet_§peed
11-07-2006, 04:31 PM
:wtf:
santacruz77
11-08-2006, 10:58 AM
ya i kno
Benefit
11-09-2006, 08:25 PM
maybe it was your clutch slave...............................?