chsdog55
10-02-2006, 12:24 AM
I currently have a stock JDM b16A turbo'd. It makes ok power but in the quest to always want more like all of us viewing the forced induction section im looking at the build. I will post what im looking at and then i have a few questions hoping you guys can give me the right advice.
SRP Pistons 9.0:1 Pistons 81.5mm Bore
Tuner Toys H Beam rods
JE Pro Rings
ARP Head Studs
Ok so my question is if i bored the block .20 over to accomadate these pistons will it require being sleeved? My understanding may be wrong but .20 should be doable without sleeving. I plan to run around 15-18 psi. And last but not least hoping 2JZkid will tune in and let me know what im looking at in labor if i bring these parts. Thanks in advance.
SRP Pistons 9.0:1 Pistons 81.5mm Bore
Tuner Toys H Beam rods
JE Pro Rings
ARP Head Studs
Ok so my question is if i bored the block .20 over to accomadate these pistons will it require being sleeved? My understanding may be wrong but .20 should be doable without sleeving. I plan to run around 15-18 psi. And last but not least hoping 2JZkid will tune in and let me know what im looking at in labor if i bring these parts. Thanks in advance.