need help!!!!

[MrEG62U]

me and a buddy of mine have been working on his ls/vtec build. we are using a type r tranny, the starter and the half shaft that we have from the ls dont fit. is the starter and half shaft different for the type r then whats used on the ls???

[§treet_§peed]

sure is....

[Vteckidd]

Halfshaft might be from an AUTOMATIC, then the bolt pattern is different.

If it wont slide in the tranny, then if hes using a HYDRO tranny with a CABLE TRANNY halfshaft, you MUST switch the AXLE seals out. IE

Hydro Tranny with HYDRO Halfshaft
Hydro Tranny with Cable Halfshaft and Cable Tranny axle seals
Cable Tranny with Hydro Halfshaft and Hydro Axle seals

if you dont have the right combo, then the shaft will only slide in with about .5in left an you wont be able to get it in an bolt it to the block

[MrEG62U]

thanks

[harper22]

if u have a type r tranny use type r tranny parts it is that simple

[SLow_POke]

if u have a type r tranny use type r tranny parts it is that simple

not necessary, ;)

[SLow_POke]

Halfshaft might be from an AUTOMATIC, then the bolt pattern is different.

If it wont slide in the tranny, then if hes using a HYDRO tranny with a CABLE TRANNY halfshaft, you MUST switch the AXLE seals out. IE

Hydro Tranny with HYDRO Halfshaft
Hydro Tranny with Cable Halfshaft and Cable Tranny axle seals
Cable Tranny with Hydro Halfshaft and Hydro Axle seals

if you dont have the right combo, then the shaft will only slide in with about .5in left an you wont be able to get it in an bolt it to the block

i just learned somthing new today :tongue1: :headslap: ,


_ernie