SPOOLIN
05-21-2006, 01:16 AM
****BLOCK IS SOLD, 600 SHIPPED BYE BYE****
I have a sleeved golden eagle block for sale.
specs:
B18B
84mm bore
O-ringed
GSR Crank Girdle Conversion
GE godzilla Sleeves
the block code is 1358665 because some people are fucking blind.
Story on this block. I made 630whp on it. Ran for several months then i started blowing headgaskets. I thought it may have been the block so We took everything apart, couldnt figure it out. Well its looks to not have been the block considering a spot in my head right where the gasket blew twice was sunken, almost like a chunk was knocked out. So im just doing a full new engine build. Its Oringed as stated with the GSR main cap girdle conversion, i know some people want that. I wanted to go ahead and post, i should have the pics up by tomorrow evening for sure. doesnt come with any accessories. I have o ring material ill ship with it to lessen any hassles, should be enough to o ring 2 more blocks. These pics are current. cyl 1 has some piston rub scratches pictured below on one side from some water getting in my oil. they arent bad at all, can barely pick at it, all other cyl are fine. at the MOST, a .5mm bore would be needed.
I have a sleeved golden eagle block for sale.
specs:
B18B
84mm bore
O-ringed
GSR Crank Girdle Conversion
GE godzilla Sleeves
the block code is 1358665 because some people are fucking blind.
Story on this block. I made 630whp on it. Ran for several months then i started blowing headgaskets. I thought it may have been the block so We took everything apart, couldnt figure it out. Well its looks to not have been the block considering a spot in my head right where the gasket blew twice was sunken, almost like a chunk was knocked out. So im just doing a full new engine build. Its Oringed as stated with the GSR main cap girdle conversion, i know some people want that. I wanted to go ahead and post, i should have the pics up by tomorrow evening for sure. doesnt come with any accessories. I have o ring material ill ship with it to lessen any hassles, should be enough to o ring 2 more blocks. These pics are current. cyl 1 has some piston rub scratches pictured below on one side from some water getting in my oil. they arent bad at all, can barely pick at it, all other cyl are fine. at the MOST, a .5mm bore would be needed.