dtmcnamara
05-14-2006, 05:54 PM
What I have here is my system that was going to be put in my accord. I dont really know if I wanna put it in there now. I pulled the wire kit out, started to pre cut some things, then said fuck it all. Nothing has been used, all new with 0 hours of play time. The sub was taken out of the box and installed in the HiFi Buys box it is in now. The prices are bellow along with all the model numbers of everything. THANKS
-----------------------------------------------------------
12W3V2-D4- $175 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00664.jpg
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00663.jpg
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00665.jpg
Specifications:
Nominal Diameter 12" (300 mm)
Continuous Power Handling 300 Watts
Voice Coil 2.25" diameter, 4-layer, Kapton former
Available Configurations Dual 2 ohm, Dual 4 ohm or Dual 6 ohm
Xmax (one-way, linear): 0.46"-0.51" (11.7-13.0 mm) depending on specific model
Sealed Enclosure Range 1.00-1.50 cu.ft. (28.3-42.0 liters)
Ported Enclosure Range 2.00-3.00 cu.ft. (57.0-85.0 liters)
VCR Technology Yes
Elevated Frame Technology Yes
-----------------------------------------------------------
KENWOOD KAC-8152D- $175 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00661.jpg
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00662.jpg
Features
* Ultra Efficient Class D Circuitry
* MOSFET Power Supply
* Torroidal Noise Suppression Filter
* Copper EE Core Power Transformer
* Dual Secondary Capacitors
* Ground Isolation Input Circuit
* Detachable Aluminum Dress Plate & Top Panel Control
* Die-Cast Aluminum Heat Sink
* Variable (50 - 200 Hz) 18 dB / Octave Low-Pass Crossover
* Switchable (Off / 15 / 25 Hz) 18 dB / Octave Subsonic Filter
* Gold-Plated Preamp Inputs and Outputs
* High and Low Level Inputs
* 2 Ohms Mono Stable
* Red Triangle Power Indicator
* Gold-Plated Screw-Type Power and Speaker Terminals
* Variable (0 - 18 dB) Bass Boost at 90 Hz
* Single-Side Terminal Placement for Cleaner Installation and Improved Wire Management
Subwoofer Mono Amp Specifications
* Amplifier Type: Mono
* RMS Power @ 4 Ohms: 300W x 1 @ 4 ohms
* THD at 4-Ohm RMS Power: 0.08%
* Bridged RMS Power @ 4 Ohms: 550W x 1 @ 2 ohms
* Speaker Level Inputs: yes
* Preamp Outputs : yes
* Built-In Crossovers: LP
* Bass Boost: 0 - 18 dB
* Frequency Response: 5-200 Hz
* Signal to Noise Ratio: 100 dB
* Dimensions: n/a
-----------------------------------------------------------
Whip Audio 1.5 Farad Cap- $50 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00666.jpg
24DCV surge with digital read out screen
-----------------------------------------------------------
Universal install kit with fuse- $30 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00668.jpg
just your normal install kit with 4 guage wire
-----------------------------------------------------------
DB Link Hi-Lo Converter- $10 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00667.jpg
connects to your car speaker wires and allows you to hook the system up to a car with no rca ports on the radio, great for stock radio cars.
TOTAL $440 for eveything. I will take $400 if someone wants in all. THANKS
-----------------------------------------------------------
12W3V2-D4- $175 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00664.jpg
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00663.jpg
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00665.jpg
Specifications:
Nominal Diameter 12" (300 mm)
Continuous Power Handling 300 Watts
Voice Coil 2.25" diameter, 4-layer, Kapton former
Available Configurations Dual 2 ohm, Dual 4 ohm or Dual 6 ohm
Xmax (one-way, linear): 0.46"-0.51" (11.7-13.0 mm) depending on specific model
Sealed Enclosure Range 1.00-1.50 cu.ft. (28.3-42.0 liters)
Ported Enclosure Range 2.00-3.00 cu.ft. (57.0-85.0 liters)
VCR Technology Yes
Elevated Frame Technology Yes
-----------------------------------------------------------
KENWOOD KAC-8152D- $175 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00661.jpg
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00662.jpg
Features
* Ultra Efficient Class D Circuitry
* MOSFET Power Supply
* Torroidal Noise Suppression Filter
* Copper EE Core Power Transformer
* Dual Secondary Capacitors
* Ground Isolation Input Circuit
* Detachable Aluminum Dress Plate & Top Panel Control
* Die-Cast Aluminum Heat Sink
* Variable (50 - 200 Hz) 18 dB / Octave Low-Pass Crossover
* Switchable (Off / 15 / 25 Hz) 18 dB / Octave Subsonic Filter
* Gold-Plated Preamp Inputs and Outputs
* High and Low Level Inputs
* 2 Ohms Mono Stable
* Red Triangle Power Indicator
* Gold-Plated Screw-Type Power and Speaker Terminals
* Variable (0 - 18 dB) Bass Boost at 90 Hz
* Single-Side Terminal Placement for Cleaner Installation and Improved Wire Management
Subwoofer Mono Amp Specifications
* Amplifier Type: Mono
* RMS Power @ 4 Ohms: 300W x 1 @ 4 ohms
* THD at 4-Ohm RMS Power: 0.08%
* Bridged RMS Power @ 4 Ohms: 550W x 1 @ 2 ohms
* Speaker Level Inputs: yes
* Preamp Outputs : yes
* Built-In Crossovers: LP
* Bass Boost: 0 - 18 dB
* Frequency Response: 5-200 Hz
* Signal to Noise Ratio: 100 dB
* Dimensions: n/a
-----------------------------------------------------------
Whip Audio 1.5 Farad Cap- $50 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00666.jpg
24DCV surge with digital read out screen
-----------------------------------------------------------
Universal install kit with fuse- $30 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00668.jpg
just your normal install kit with 4 guage wire
-----------------------------------------------------------
DB Link Hi-Lo Converter- $10 obo
http://i20.photobucket.com/albums/b230/dtmcnamara/DSC00667.jpg
connects to your car speaker wires and allows you to hook the system up to a car with no rca ports on the radio, great for stock radio cars.
TOTAL $440 for eveything. I will take $400 if someone wants in all. THANKS