Whats your opinion on intake manifolds for a GSR?

[carbon_crash]

Just wondering what people's preferences are as far as an aftermarket intake manifold bumping HP?

Skunk 2?
Blox?
Weapon R?
Venom?
Edelbrock?
????

by the way, this is for a NA GSR, whats your opinion?

[drmcivicsi]

edelbrock

[carbon_crash]

reason? you have one on your motor? any difference?

[KevinT707]

AEBS, not too expensive & proven to make power. Will run you aobut $180.

[LS2ner]

kevin, they havent made a AEBS for the GSR yet have they? other than that...skunk2 pro series.

[Jdm94Coupe]

yea i think they have, i seen mike sellin one a while back though...... skunk2 pro series though

[carbon_crash]

I checked on AEBS' website and I only found a manifold for a B16 or a B18c5, but no GSR. do they sell one for a GSR?

[KevinT707]

I checked on AEBS' website and I only found a manifold for a B16 or a B18c5, but no GSR. do they sell one for a GSR?
Hrmm, I could've sworn they already came out with one. If not then my bad.

[1civic]

We got one On my Buddy's GSR.... I still have the box too...It may have the part number still on it, If so I will post it... :goodjob:

[carbon_crash]

1civic- if you still had that part number that would be great!

[IntegraXTR]

last I checked they didn't have one yet but I could be wrong, other than that go for the skunk2 pro IM.

[99SI]

AEBS did finally come out with a GSR IM. I run the AEBS on my B16 and I made power all the way to 9300 rpms before dropping off. I think that the manifold helped out a lot in keeping power that high. For the cost I would definately say AEBS. If cost is not a concern then S2 Pro.

[LS2ner]

Me personally, im gonna try out BBS new SSI ITM. Ill post dyno's for everyone so we can see how it does.

[1civic]

Sorry it took so long...I was out of town... This is the part number though

Part #:935-59003 /GSR- Satin

[fight club]

run itb's and call it a day.

[HachiDori]

ITBS FTW!!!!!

[Turbodude06]

I got Skunk 2 it works good