IntegraXTR
03-02-2006, 01:51 PM
Ok, so I just installed a V-AFC version 1 in my car, I got the instructions from apexi-usa.com and even printed that and the updated installation diagram where it shows you where the VTM wire goes, problem is in the WH-2 diagram, it shows where to connect the VTM wire, but its not there on my ecu harness. Plus it states that *some vehicles may not have a VTM signal*. So am I good? Is this something I should worry about?
here's the link, scroll down and find installation update
http://apexi-usa.com/support_installation.asp
here's the link, scroll down and find installation update
http://apexi-usa.com/support_installation.asp