Log in

View Full Version : Help with teg.


Bishop
02-16-2006, 11:14 AM
So i noticed that the cv boot on the axle has ripped in half. Any body know of a write up for replacing the boot or axle?
Evil Goat
02-16-2006, 01:00 PM
replace the axle....if the boots cracked theres sure to be dirt in there anyway...pretty straightforward though....try honda-tech or google and see what you come up w/ im sure theres a write up out there somewhere
Bishop
02-16-2006, 01:01 PM
replace the axle....if the boots cracked theres sure to be dirt in there anyway...pretty straightforward though....try honda-tech or google and see what you come up w/ im sure theres a write up out there somewhere
Yeah i know i need to replace the axle...i already asked on honda tech but no one seems to know shit over there.
Blitanicle99
02-16-2006, 04:36 PM
Michell on demand is free online. Also napa.com has instructions for everything.
IntegraXTR
02-16-2006, 04:38 PM
if you don't have the money right now or just don't feel like spending the money, the cut the boot off, take all the grease out of there, and push the axle back in, that will hold up for a while.
Bishop
02-16-2006, 04:45 PM
It drives fine and all...the boot is just ripped in half.
NAIZBST
02-16-2006, 09:39 PM
all you need is a 17mm wrench and socket, and a 30mm socket for the axle nut
it's not that hard to replace
3kgtdrvr
02-16-2006, 10:07 PM
...and dont pull on the axle to get the inboard joint out of the tansaxle or itll pop apart :goodjob:
Evil Goat
02-17-2006, 06:24 AM
+1...and arent the drivers side axles attached to the blocks as well? and buy a haynes manual while youre at it...it will become your best friend
speedminded
02-17-2006, 12:11 PM
If it's not clicking then you don't need to replace the axle, just take the axle nut off (gonna need a replacement if you rape it trying to take take out the lil safety punch) Pull the axle out (yeah, it's a 2 piece axle so pull on the inner one closest to the transmission) Cut the bands and pull the boot off, clean the CV extremely well if it's dirty inside....replace the boot, pack it, reband it (you're gonna need a banding tool to put the new CV boot bands on) stick the axle back in, put the hub/rotor assembly back on, and torque the axle nut to spec. done.