OBD2 GSR into OBD2 LS swap help!!!

[spoolinb18]

I've looked and looked and looked but didn't find anything worth meaning. Soo here i go. I have already swapped the engine in so the hard work is done. Now i need to wire up vtec and the secondaries and anything else that i have to wire up. i've ran into a lot of obd1 into obd1 or obd2 to obd1 but no obd2 to obd2.

I have the green vtec solonoid but i dont have the second one required, i think its oil pressure. I have the secondary plugged in but i dont know hwere the wires go.

if someone can help. please help.

[justinxecushyn]

bump, i need 2 know this one too

[IntegraXTR]

screw the secondaries, you don't even need that, its just like a throttle body plate, but four of them inside the manifold and they open at 5800-6k rpm or so for full throttle, leave the secondaries out or just go buy a single stage design manifold like skunk2, aebs, etc.

[Jdm94Coupe]

or u can zip tie the secondaries open, take a good 5-10 minutes to get it right but it works!!!

[Trey]

This may help....

http://www.phear7imports.net/trey/6gen