can a twin cam d16a1 motor head fit a d16z6

[camrycivic]

can a twin cam d16a1 motor head fit a d16z6 in a honda civic jw :rolleyes:

[exjnv]

..wha? you mean b16? d-series motors are all single cam. and if they are both d-series then yes but you cant swap single cam and dual cam heads with eachother

[Cool Cat Racing]

No, not all D series are single cam. The integra from 86-89 came with a D16A motor that was a dual cam. As for swapping it over, I believe it can be done like any other D series swap but I'm not sure. I'm sure some here knows for sure.

[camrycivic]

bump

[camrycivic]

bump

[IntegraXTR]

can a twin cam d16a1 motor head fit a d16z6 in a honda civic jw :rolleyes:

no it will not bolt up, as stated above, the old old tegs came with dual cam but tryin to put that on a single cam aint going to happen.

[punkr6]

no it will not bolt up, as stated above, the old old tegs came with dual cam but tryin to put that on a single cam aint going to happen.
yea!^^^^what he said

[thebense]

yup. Also, that block won't bolt up to a 88-00 transmission either. the d16a1 is somewhat of a red-head step child. The only thing that I believe you can use from it is the pistons. Since the d16a1 head is dual cam, it has a large combustion chamber, to achieve normal compression it used high dome pistons. People often take these pistons (like 30 bucks a piece from a dealer) and put them in their d16z6s to achieve higher compression.

[camrycivic]

thanx

[sirhatch1030]

sure wont ive tryied it.

[OG-Skinny]

sell me that good d16a1 bottom end