PDA

View Full Version : which amp(s) to get?



Nittanys1
12-24-2005, 10:06 PM
ok so Im looking into getting new audio and was needing some opinions on which setup to go with? I was either going to get a 5 channel amp or 1 channel & 4 channel

5ch:
-Front 100watts x 2
-Back 25 x 2
-Sub 250 x 1

OR

4ch:
-Front 75 x 2
-Rear 75 x 2

&

Mono 250watts

BanginJimmy
12-24-2005, 10:44 PM
what fornt stage, what rear stage, what sub? price of each amp?

Nittanys1
12-24-2005, 11:47 PM
These are the specs on the amps. the subs I will be using consume 125watts per sub and Ill be getting two. The make and model is not going to be mentioned I dont want the image there..price...leave that to me...


5 Channel
Rated Power Front Channels: 100 W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V)
Rated Power Rear Channels: 25 W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V)
Rated Power Subwoofer Channel: 250 W RMS @ 1.5 ohm-4 ohm (11V-14.5V)
THD at Rated Power: <0.03% @ 4 ohm (front and rear ch.)
<0.05% @ 4 ohm (subwoofer ch.)
S/N Ratio (Front & Rear Channels): >108.5 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
S/N Ratio (Subwoofer Channel): >95 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
Frequency Response (Front and Rear Channels): 5 Hz - 30 kHz (+0, -1dB)
Frequency Response (Subwoofer Channel): 5 Hz - 300 Hz (+0, -1dB)
Damping Factor (Front and Rear Channels): >200 @ 4 ohm / 50 Hz
Damping Factor (Subwoofer Channel): >500 @ 4 ohm / 50 Hz
Input Range: Switchable from 200mV-2V RMS to 800mV-8V RMS

4 Channel
Rated Power (4 Channel Mode): 75 W RMS x 4 @ 1.5 ohm-4 ohm (11V-14.5V)
Rated Power (Bridged to 2 Channel): 150 W RMS x 2 @ 3 ohm-8 ohm (11V-14.5V)
THD at Rated Power: <0.03% @ 4 ohm per ch.
S/N Ratio: >108.5 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)
Frequency Response: 5 Hz - 30 kHz (+0, -1dB)
Damping Factor: >200 @ 4 ohm per ch. / 50 Hz
>100 @ 2 ohm per ch. / 50 Hz
Slew Rate: ±25 V / µS @ 4 ohm per ch.
Left to Right Channel Separation: >75 dB @ 1 kHz
Input Range: Switchable from 200mV-2V RMS to 800mV-8V RMS

Mono Block
Rated Power: 250 W RMS @ 1.5 ohm-4 ohm (11V-14.5V)
THD at Rated Power: <0.05% @ 4 ohm
S/N Ratio (All Channels): >95dB below rated power (A weighted, 20 Hz - 20 kHz noise bandwidth)
Frequency Response: 5 Hz - 500 Hz (+0, -1dB)
Damping Factor: >500 @ 4 ohm / 50 Hz
Input Range: Switchable from 200mV-2V RMS to 800mV-8V RMS

Boosted S60R
12-25-2005, 09:56 AM
get the 4channel and the mono alot more control and will look alot better in your install

ACCORDRYDA23
12-25-2005, 12:37 PM
^^ wut he said.... only prob i have with goin wit the five channel is if something happens to either of the channels goes then amp is pretty much useless... you would have to take the amp out to get fixed and shit... i say go with the 4 channel and the mono block.. holleerrrrrrr

Nittanys1
12-25-2005, 02:00 PM
get the 4channel and the mono alot more control and will look alot better in your install

shh u...u know my plans... :D

BanginJimmy
12-25-2005, 02:44 PM
I would imagine both amps are high end SQ amps, so it would depend on what you are looking for in the install. 5ch would provide a simpler install, and for a high end install, which I'm pretty sire you are going for, you arent going to be using the system anyways if there is an amp down.

personally I would do the 5ch for ease of install, but it really comes down to what look you are going for. I seriously doubt you will notice any sound difference between the 2

Nittanys1
01-02-2006, 07:20 PM
I just got a call from my best friend and he is moving to Chicago on wends. :( and he is selling his car....so he asked me if I wanted to buy his amps from him for dirt cheap...two xtant amps for $150 so he came over and I had them out of the car in 5 mins...so now im going to be using these amps with and xtant sup set-up prob three subs...Im thinking of taking the amps and opening them up and showing the mother board instead of the amp part...making it more of a wow factor then just amps sitting in the trunk...

so the amps are the Xtant A4004 and 6001 now I need to talk to my friend who has the in with xtant to get some subs...maybe I'll go with 4 :D

Ohh and I still have my first amp sitting in my closet, its a 5 channel xtant with all the goodies...only thing is its fried and xtant would fix it for $120...but im prob not gonna do anything with that...

BanginJimmy
01-02-2006, 07:34 PM
so what were the other 2 amps you were looking at?

Nittanys1
01-02-2006, 08:38 PM
they were the JL audio amps