new here .. thought I'd say hi :)

[miro_gt]

just registered and thought I'd say hi :) .. I wasn't quite sure where to post that but I hope it's OK here.

I have a 95 Civic EX stock block that I turboed with GReddy 15G kit. I'm running 8psi at the moment...I may post a picture later, it's 1:45am right now .. lol

anyways, hi to everybody ... hope that this forum is quite interesting :)

[1/4Mile]

Hello my friend, you can post here just make sure you go to the top of the page and post in the Mew Members and FAQ's

[miro_gt]

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MzYxNzZzNDEzZGZkMzF5NTQx.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MzYyMTZzNDEzZGZkMzF5NTQx.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MzYxODZzNDEzZGZkMzF5NTQx.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MzYxOTZzNDEzZGZkMzF5NTQx.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MzYyMDZzNDEzZGZkMzF5NTQx.jpg

all comments welcome :)

[D16Civic]

welcome to the site, always nice to see a turbo d
What kind of power your car putting down?

[miro_gt]

thanks

about the power - I'm not sure, the car has never been dynoed ... but I run 8psi ... well I've seen 8.5psi at 4th gear though... with like 20 deg total timing ... so I'd say about 170-175WHP :)

[miro_gt]

oh, I guess most of you guys have seen my car as I go at the meetings at North Poing Mall for the last 3 - 4 months ... :) .... I just haven't posted since now :)

[1/4Mile]

Your setup is pretty nice. You might want to think about getting it dyno'd though. What kind of injectors and fuel management are you running.

[mocha latte cupcake]

very nice set up

[miro_gt]

Your setup is pretty nice. You might want to think about getting it dyno'd though. What kind of injectors and fuel management are you running.

thanks
I run the stock injectors and fuel system, with the EManage that came with the kit. I tried to hook up my RC 440s but I didn't like how EManage controlls them so I ended putting my stockers back on :) I'll probably switch to Hondata s300 and then rise the boost more

at 8psi (8.5 sometimes) and 11:1 A/F (according to my PLX M250) I datalogged 95% duty cycle at like 6500 RPM - that was the max duty cycle that I saw :) So It's all good for now :)

[Tracy]

welcome!

[mp5o]

thanks
I run the stock injectors and fuel system, with the EManage that came with the kit. I tried to hook up my RC 440s but I didn't like how EManage controlls them so I ended putting my stockers back on :) I'll probably switch to Hondata s300 and then rise the boost more

at 8psi (8.5 sometimes) and 11:1 A/F (according to my PLX M250) I datalogged 95% duty cycle at like 6500 RPM - that was the max duty cycle that I saw :) So It's all good for now :)

Want to sell those rc440's?

[miro_gt]

Want to sell those rc440's?

ah .. no :) I plan to use them later