lamuerta1253
03-07-2012, 01:38 PM
so check it out i have a JDM F20B laying here and i was thinkin of boosting it and change the pistons to "CP"(10.1) sence the stock one are already 11.1 compression and rods to "Eagle"(H beam) and leave the sleeve part alone sence it has iron sleeves already :D but the question is how much of PSI can this motor handle?? My goal is to make around between 300HP to 400HP and what kind of turbo would i need also?? :thinking:
This is what i have so far to reach my goal:
JDM F20b motor
ARP head studs
OEM head gasket
precision 550cc injectors
Skunk2 IM
Skunk2 72MM TB
255 walbro fuel pump
and again idk what size turbo to add on this setup btw this is going on an EG hatch with LSD GSR tranny so yea "F2B Turbo"!:goodjob:
This is what i have so far to reach my goal:
JDM F20b motor
ARP head studs
OEM head gasket
precision 550cc injectors
Skunk2 IM
Skunk2 72MM TB
255 walbro fuel pump
and again idk what size turbo to add on this setup btw this is going on an EG hatch with LSD GSR tranny so yea "F2B Turbo"!:goodjob: