PDA

View Full Version : Throw out bearing



mosei
11-07-2011, 10:15 PM
Help I have a 98 legacy that had a bad pressure plate that

Cause my clutch to slip. I open up the car after goin to the junk yard an taking

The plate of another car. So I put it on but now my car won't go in gear

I had to open back up the transmission only to find that my bearing

Clips keeps coming of when I push on the clutch. I need to how this lips

Is suppose to go back on so that it won't come of again. And I would like

To know where I can buy a new pressure plate,just the plat only. And if anyone could send me a pic of it that would be great to.

-EnVus-
11-07-2011, 11:32 PM
I looked and a new pressure plate runs around $100 why not get new ?

Echonova
11-08-2011, 06:33 AM
http://i1084.photobucket.com/albums/j402/Echonova2/dei.jpg

mosei
11-08-2011, 02:51 PM
Yes looking for a new one right now,but I am wondering if that
Is the reason why my clutch pedal is staying to the floor when I push on it

mosei
11-08-2011, 02:54 PM
I found one online today that cost 73 and some change.
Think I will get it.plus it's the oe part as well so I will go with that,
Lol I can't wait to get back into that car. I never new Subaru was
This good of a car

mosei
11-08-2011, 02:55 PM
Never knew lol

Theycall_Metue
11-08-2011, 03:19 PM
replace pilot bearing while your at it and grease that new throw out bearing before installing it

mosei
11-22-2011, 10:27 PM
Yes so i got the new plate and my car is like new again lol. now to sell my 91 crx

Benefit
01-03-2012, 10:19 PM
LMAO ECHONOVA HAHHAHAHA