View Full Version : 99 si b16 trans prob
terrytowe22
09-30-2011, 06:28 PM
When in gear an letting off Clutch makes a roar noise I push in clutch it stops
Any idea? Still goes in gear fine
big mac
09-30-2011, 06:45 PM
throw out bearing
terrytowe22
09-30-2011, 06:49 PM
But while driving down the road and I let of the gas it does a roar noise
It's the release/throwout bearing - I have the exact issue but I put anti-seize between the fork/slave cylinder piston to stop the squeaking noise - but still have bearing chatter when off the clutch. Time for a new clutch my friend!
terrytowe22
09-30-2011, 08:43 PM
Sure cause it sounds like gears grinding when I let off
Clutch grabs good and shifts find
4wslude
09-30-2011, 09:37 PM
its the imput shaft bearing on the tranny my tranny does it also and when you push in the clutch it stops and when you let it out in when it starts and the throw out bearing only work with the clutch pushed in and it stop working when the clutch is out because when the clutch is pushed in is when the throw out bearing is up againest the pressure plate spinning
Starrfire
09-30-2011, 10:02 PM
luckily they aren't too expensive
terrytowe22
09-30-2011, 10:07 PM
It's a buddy car so throw out bearing? Not expensive but pulling trans is pain
EmminoDaGreat
09-30-2011, 10:15 PM
When you pull trans you will see if the throw out bearing is noisy, if it is there is your problem, also grab the input shaft and if it moves, then you input shaft is probably the cause of the noise.
Yeah either way to really get in deeper you'll have to pull the trans - not too difficult of a job like most think.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.