View Full Version : b16 slow rev problem
HolleyStyle
07-03-2011, 02:58 PM
just put a b16a into a 99 civic, got as tps code, ive tried to check it and the voltage is way high, so i put a new one on it and it does the same thing. but the problem is that it revs really slowly, any opinions as to what else i should be checking or is the tps what would be causing this problem
JF868849
07-03-2011, 03:18 PM
Check the timing
Theycall_Metue
07-03-2011, 08:19 PM
i believe the tps and map plug is interchangeable. make sure it isnt mixed up also.
turbob20
07-06-2011, 11:29 PM
x2 on the plugs!
flywheel is too heavy :jester:
TPS and MAP plugs are incorrect, timing is off, or ECU is bad.. im sure there is a CEL, check it and post the code.
terrytowe22
07-07-2011, 12:06 PM
Can't u adjust the tps sensor?
Can't u adjust the tps sensor?
you can, but even a TPS sensor adjusted VERY wrong wont make a car rev THAT slow... only it being backwards or mix-matched plugs would do that.
now that i think about it, im assuming you are going from a D16y7 to a B16? if you are and you are using the original D16y7 engine harness, swap the 2 OUTER wires on the TPS plug... D16y7 throttle bodies use a backwards sensor. Although, if your coming from a D16y8 then disregard what i just posted LOLOL
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.