psycho_freke
05-25-2011, 04:36 PM
I'm doing a swap and very close to dropping the motor into the bay of my civic. I'm having a slight issue with the wiring though. The engine is off of a '96 GSR and I'm swapping into a '94 Civic DX. I've pulled the Vtec and KS wires from the GSR's harness and snapped them in on the Civic's harness. No problem... but now I'm trying to pin the wires to the ECU connector and it looks like the pins are different and I can't seem to get them to snap in. Anyone have any suggestions?