wheel bearings

[Eg4LiFe]

ok i have a 92 civic hatch but it has integra brake rotors, calipers and stuff like that all around. So my front pass. wheel bearing went bad and need to change it, should i get a wheel bearing for integra ( b series) or one for the 92 civic? plus it's a b series swap too

[*EFilliated*]

so it has integra spindles in the front? if so get them for whatever year integra they came off of

[-EnVus-]

Do the year for the Teg the front is off of....

[Eg4LiFe]

Ok thanks guys but one more question if the rotor feels like it don't want to spin and it's making a scratchy noise that means it's bad right?

[D3UC3S]

Usually you hear its bad when your driving and it gets worse when you steer towards the bad hub. Its almost easier tojust find a new spindle and slap it in.(from the correct year integra, of course)

[*EFilliated*]

how are the pads? ur rotors are most likely shot and need replacing


Ok thanks guys but one more question if the rotor feels like it don't want to spin and it's making a scratchy noise that means it's bad right?

[Tech5]

To tell if the bearing is bad you jack that side up not on suspension parts but frame and wiggle the whole wheel up and down side to side if any play it's bad ....


Also you would need the bearing for that integra and also it's a press in and out so you can't do this unless you have the press .....And no parts store rents them either I have a snap on and it cost me 900 bucks

[D3UC3S]

^^ yeap PITA. Just buy a whole new spindle. Would be alot more cost effective and easier to install.

[Eg4LiFe]

ha thanks guys but pep boys got it for me already. they do press in and out the bearing...