PDA

View Full Version : spark issue no spark cylinder 4



94_teg_ls
03-18-2011, 11:25 PM
no spark just on cylinder 4 swapped dizzys with a good one and wires it like its not getting the good to go to spark help

SLow_POke
03-18-2011, 11:30 PM
you're not getting spark or good enough spark? and u even swapped to a known good diizzy AND wires? with the same issue?

94_teg_ls
03-18-2011, 11:33 PM
yes pulled it off my gsr no spark at all put the dizzy back on my running car and drove it home so its just that car

slostang
03-19-2011, 11:38 AM
main relay or ECU

94_teg_ls
03-19-2011, 11:53 AM
dont say ecu and we have fuel and spark every where else so its not relay

gsrteg
03-19-2011, 03:24 PM
Check the spark plug for the cylinder, maybe the gap clearance is not correct or the spark plug has been fouled. Oh yea, make sure your spark plug wires are in the correct sequence/locations on the dizzy. Check if your fuel injector plug for that cylinder #4 is snug and plugged. Keep us updated.

94_teg_ls
03-20-2011, 10:35 PM
still no start compression is good spark is good timing good fuel good swapped ecu's main relay new dizzy harness

specs
b16 block sleeved 84mm cp 9.1 cr pistons eagle rods
built gsr head performer x manifold
3 bar map 750 cc injectors was running fine 20lbs daily
car sat for a while in the back yard let it run it was missing on cylinder 4 -no spark thats now fixed but there is no spark no spudder pop or anything

Thegrizz
03-25-2011, 08:52 AM
i have a boosted del sol and i let it sit for a good 4 months. then cranked it. it turned out the connection on the #4 450cc dsm was bad. so pull your injectors,clean them and put them back in.they get clogged if their not run. worht a shot anyway.and change the fuel filter to help the cause. hope that helps bro.btw nice setup

Tech5
03-25-2011, 04:34 PM
What do you mean no spark in number 4 ? Coming out of the wire or that cylinder is skipping and you just pulled that wire off?

If it's not getting fire from the wire but the dizzy cap and all works as you stated you put it on your car and ran fine , what about the wires?