good price on sleeving b18 block + o-rings?

[marcos713]

I've been looking for a place to get my block sleeved and o-ringed. Quotes I've been given have ranged from 1075-1250 for just sleeves not including the o-rings or final bore and hone. I'm looking at either Golden Eagle sleeves or Aebs sleeves. Basically I'm just wondering if any1 knows of a place that does it at a lower price.

I found this Aebs dealer that has a package for 1449 + 150 for the o-rings.. Good deal?
http://www.larryspower.com/engine/AEBS.html

Any input would be helpful. Thanks IA :goodjob:

[Berta]

Robert at Golden Eagle had my block sleeved for $850 shipped back to me. And they did the finish bore to my pistons, which i got to him for the work to be done.

[marcos713]

Anyway I can get in touch with him?

[marcos713]

any1 else have any input?

[crashtke]

Depends on the sleeves you use. But I can't imagine it being much cheaper than the place that he quoted you above...if that is including sleeves and boring the block, that is a pretty darn good price.

[loSiRcity]

i had my sleeves done by larry's power as well. good work and good people. they actually hooked me up with darton mid sleeves + o-ring for a good price. no complaints at all

[Berta]

Robert @ Golden Eagle Manuf.
909-592-4311

I think that he is the only person that answers the phone anyhow...

I had another block sleeved with Darton solid deck sleeves by ERL, but that was some time back. lol They were alot more expensive then as they are now. It was $1700 back in the day.... :/

[marcos713]

Ok so I have another question and I didn't start another thread just for that.....

3angle valve job? Would I need it? If so, is there a shop that does it for a good price?

[Slomaro Z28]

Ok so I have another question and I didn't start another thread just for that.....

3angle valve job? Would I need it? If so, is there a shop that does it for a good price?

Goza Machine shop, it's in Acworth. 770-974-2088 Ask for Tommy

[marcos713]

Goza Machine shop, it's in Acworth. 770-974-2088 Ask for Tommy

Ive already been there...im jus wondering if the valve job is necessary or if il see any type of gain or loss if I do or don't do it...and im shopping around for prices as well

[marcos713]

A couple more questions....what size oil restrictor should I use on my t3/to4e turbo? And what size oil lines? Thankss