machine shops?

[Infamous_1]

Im taking a block to a machine shop and so i was wonder how much they would charge to hone, align , and hot tank a block?

Also to balance and polish a crank?

Pls lmk I need to finish my build

[Bacon]

Chastain Engines in Jonesboro can do it. Give them a call and they should be able to give you a ballpark figure of what you'd expect.

770-478-7780

[Infamous_1]

That's alil too far for me...need some place north east of ATL

[Thegrizz]

Goza machine shop.its on mainstreet in acworth.they do a good job .not sure about everything else though but they charge $40 a cylinder to bore it out. their number is 770 974 2088.their in Kennesaw/Acworth area.

[Black4DrEK]

here are a few prices from the machine shop, I go to.

This is just to give you some prices, Not sure what else is out there price wise.

Block:

Clean- spray washer $100

Fresh Hone $40

Bore AND Hone $120

resurface $80

If im not wrong, Its $80 or so for Polishing cranks.

But Its not in your area.

[Infamous_1]

the spray washers clean off ugly paint off the block? its been painted on twice
and name of the shop mite take it there

[Black4DrEK]

Scotts Machine Shop