View Full Version : ecu and motor swap
Go_Fast
01-20-2011, 12:07 PM
can you put a stock b18a motor and a pr4 ecu into a '95 integra gsr and have it run fine?
if so what about the extra vtec wires?
will it pass emissions?
Cynical 1
01-20-2011, 12:33 PM
it will run.
you will have to do some rewiring.
emisions - only if everything is hooked up, and the engine is the same year or newer (with newer emissions exuipment installed), as they will check.
Go_Fast
01-20-2011, 12:43 PM
what if i get a b18 block, b16 head, and a stock p28?
blown_ss
01-20-2011, 05:31 PM
what if i get a b18 block, b16 head, and a stock p28?
it will run but not good. a p28 is for a d series. the engine set up will work but you need a different ecu.
Go_Fast
01-20-2011, 06:32 PM
it will run but not good. a p28 is for a d series. the engine set up will work but you need a different ecu.
what ecu should i get?
blown_ss
01-21-2011, 09:43 AM
by b18 do you mean ls or gsr? if you are doing a ls/vtec then you will need to get it tuned.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.