so i traded the k20's lol

[jdmshytyo87]

ok here ya go,, i trade both my k's for a full GSR swap, axels, linkage, wired already for obd1, p30 ecu, b16 tanny, hasport mounts, skunk2 intake, 4-1 header. i mean the works all for my k20a3 k24a4 just the motors bare.so how did i do ? 234302o234301.234300.234299?234298

[skittle_107]

i would've sold one k20 and built the other.

[Got Milk?]

lol wut

move this to WTF section

[cm7k24]

i had a feeling you weren't going through with dropping the K in it.

[Glade]

Lol!

That's a B16 head.

[94_teg_ls]

why do you think its a b16 head

[Glade]

why do you think its a b16 head

Look at the intake manifold.

[Sir_Christopher]

yeaa... got you got worked, "gsr" bends down, not up

[94_teg_ls]

read a book

p30 ecu, b16 tanny, hasport mounts, skunk2 intake, 4-1 header

[Glade]

read a book

p30 ecu, b16 tanny, hasport mounts, skunk2 intake, 4-1 header
PWNDDDDDDDDDDDD!!!!!!!!!!!!!!!!!!!!!!!!

[Catnip]

Since when do Skunk2 intake manifolds not have a raised area with the Skunk2 symbol?

[civicmantim]

The orignal skunk2 manifold didn't have it, just the pro series manifold.

[Black4DrEK]

^ x2..

Does the Head say PR3 or P72?

Anyways.. I wouldnt have done that trade, Straight up..

[mistergou]

well prob a good deal if you didnt have a whole lot of money in the K motors, but if you think you got a good deal then that good, plus your car be on the road now!

[Formally...]

It's a GSR head. Water neck for upper rad hose comes out front of head on GSR and LS and back of head on B16 and Type R. I say good deal if you get a running full swap so you can get your car on the road.

[94_teg_ls]

It's a GSR head. Water neck for upper rad hose comes out front of head on GSR and LS and back of head on B16 and Type R. I say good deal if you get a running full swap so you can get your car on the road.

you can see that i was looking so hard to see the neck but i could not positively see it

[Drummerboy]

Should have stuck with the K's man. K hybrid motors are bananas!

[jdmshytyo87]

yea the k's sounded nice but to be real a built gsr or any bseries motor in fact will walk all over k's iv seen it in person.. and plus i only had 400$ in both motors.. and it just coast way to much money for a k swap. i think i did good i mean its a 2700$ swap for only 400$ i had in mine... i just think over all the k series are over rated unless u have the money to put in them....

[Genji-Sama]

K swaps are just soooo secksy, but I would have to say you came out on top here, can't say I would've done that trade, but still.....