PDA

View Full Version : b20/gsr/ls help



em1si
05-30-2010, 07:34 PM
here is the problem im having. the b20 block and the cable gsr tranny holes are not lining up at all they are like half an inch off and the clutch is hitting the tranny casing. the T braket only bolts up with two bolts.. and the stock Ls DA tranny mount dont come close to bolting up.. any idea's:thinking:

em1si
06-01-2010, 05:43 PM
any ideas

Starrfire
06-01-2010, 06:59 PM
HMMMMmmm. What did the b20 come out of? An older prelude? If so take it outside and smash it into little pieces with a sledge hammer. Maybe even use the valve cover as a jello mold. That's about all it's good for.

punkr6
06-01-2010, 11:08 PM
HMMMMmmm. What did the b20 come out of? An older prelude? If so take it outside and smash it into little pieces with a sledge hammer. Maybe even use the valve cover as a jello mold. That's about all it's good for.

lol, More info needed. You haven't even listed what chassis you're doing this to...

em1si
06-02-2010, 08:04 PM
IN A 92 4 DOOR INTEGRA

Starrfire
06-02-2010, 08:48 PM
No, what is the engine? is it a b20a?

Barefoot
06-03-2010, 12:32 PM
No, what is the engine? is it a b20a?

need to know

em1si
06-04-2010, 06:32 PM
B20B