PDA

View Full Version : d series won't hit 7200 rpm



jdmalltheway
05-22-2010, 12:18 AM
I didn't have any spark so i switch out the whole internal distributor from a 1.5 dx obd1 to my obd1 1.6 si distributor. if the car is just in neutral i could rev to 7200 rpm but if i drive it and step on it, it won't go more than 5200 rpm. it seem like it want to go over it but then it get kick back under 5200 rpm like a rev limiter. i need major help cause that is where all the power is.

seanrg1116
05-22-2010, 12:53 AM
what engine are you working with???

jdmalltheway
05-22-2010, 08:18 AM
d16z6 single cam vtec

jdmalltheway
05-22-2010, 10:34 PM
DAMN NO ONE DON'T WANT TO HELP. COME ON I NEED HELP REALLY BAD. I AM NEW TO THIS.

H1Cblacknight
05-25-2010, 12:05 AM
this just happened to my friends car. any CEL's? did vtec work before? check to see if theres a code even though its not showing

98blackcivic
05-25-2010, 12:09 AM
limp mode?
so basically youre using the wrong ecu?
what?
idk man

Bacon
05-25-2010, 02:51 AM
Sounds like limp mode.

jdmalltheway
05-25-2010, 10:04 AM
yea vtec was working but i haven't check the codes yet.

jdmalltheway
05-25-2010, 10:05 AM
limp mode?
so basically youre using the wrong ecu?
what?
idk man

using the right ecu. p28

jdmalltheway
05-25-2010, 10:05 AM
this just happened to my friends car. any CEL's? did vtec work before? check to see if theres a code even though its not showing

yes vtec was working properly

Engineernik
07-19-2012, 03:22 PM
i have the same prob but i hit 6000 rpms and sometime when im in 4th hittin 4000 my eng light cuts on and when i cut the car off the lights goes as well

green91
07-19-2012, 06:07 PM
i have the same prob but i hit 6000 rpms and sometime when im in 4th hittin 4000 my eng light cuts on and when i cut the car off the lights goes as well

Please read post dates before replying! Theres no sense in bumping a useless thread that died over 2 years ago.

RBS
07-20-2012, 03:14 PM
lol

jdmalltheway
07-24-2012, 10:11 PM
i have the same prob but i hit 6000 rpms and sometime when im in 4th hittin 4000 my eng light cuts on and when i cut the car off the lights goes as well

this thread been dead already but after a couple weeks the distributor crack on me so i guess one of the wires had a cut in it or else something wasn't acting right in the distributor and cause high voltage to melt my rotor inside of it and crack the cover of the dizzy and replaced my dizzy and redo my timing just incase it had jump a tooth and now the car is running fine...only problem is still have a cell for vtec n speed sensor but because i'm using a cable tranny and the speedometer cable is worn out where it connect to the cluster.