View Full Version : b16 stuck in safe mode
Code-Aye
05-03-2010, 02:18 PM
i have had my b16 for a while now, i was obd0 running a pr3, and my car was stuck only reving to 3.5. so i read some fourms, i then went back and wired my distributer to the ecu. still same problem. so i sucked it up and conveted my car to obd1, i have a p30 ecu, obd1 distributer, and the conversion harness. i am still having the same problem. any ideas of what could be my problem:thinking:
Barefoot
05-03-2010, 03:34 PM
read
http://www.superhonda.com/forum/f146/limp-mode-limp-home-mode-etc-236192/
Code-Aye
05-03-2010, 03:39 PM
I have a brand new distributer.its for crank angle
silverDA
05-03-2010, 03:40 PM
limp mode.
Barefoot
05-03-2010, 03:45 PM
I have a brand new distributer.its for crank angle
huh
Code-Aye
05-03-2010, 03:48 PM
My cel is for crank angle.and my distributer is brand new. So I dont know how im having this problem
Barefoot
05-03-2010, 04:40 PM
what code are u getting
00Civic
05-03-2010, 04:46 PM
I googled it up....I would just suggest to try and replace the crank angle sensor .....have you done that?
Code-Aye
05-03-2010, 05:56 PM
When I was obd0 code 4, 15, 22. Since i have gone obd1 I need to go get a toggle switch so i can read the codes
Code-Aye
05-03-2010, 05:59 PM
I googled it up....I would just suggest to try and replace the crank angle sensor .....have you done that?
The crank angle is in the distributer, and the distributer is brand new
00Civic
05-03-2010, 06:37 PM
maybe check for exposed or shorted wires? going to the ecu? just an idea
Code-Aye
05-03-2010, 06:39 PM
^^
I cant even tel you how many times I have done that
00Civic
05-03-2010, 07:08 PM
what about the plugs to the sensor? is it corroded?
Barefoot
05-03-2010, 07:26 PM
put that jumper in
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.