b16 stuck in safe mode

[Code-Aye]

i have had my b16 for a while now, i was obd0 running a pr3, and my car was stuck only reving to 3.5. so i read some fourms, i then went back and wired my distributer to the ecu. still same problem. so i sucked it up and conveted my car to obd1, i have a p30 ecu, obd1 distributer, and the conversion harness. i am still having the same problem. any ideas of what could be my problem:thinking:

[Barefoot]

read

http://www.superhonda.com/forum/f146/limp-mode-limp-home-mode-etc-236192/

[Code-Aye]

I have a brand new distributer.its for crank angle

[silverDA]

limp mode.

[Barefoot]

I have a brand new distributer.its for crank angle

huh

[Code-Aye]

My cel is for crank angle.and my distributer is brand new. So I dont know how im having this problem

[Barefoot]

what code are u getting

[00Civic]

I googled it up....I would just suggest to try and replace the crank angle sensor .....have you done that?

[Code-Aye]

When I was obd0 code 4, 15, 22. Since i have gone obd1 I need to go get a toggle switch so i can read the codes

[Code-Aye]

I googled it up....I would just suggest to try and replace the crank angle sensor .....have you done that?

The crank angle is in the distributer, and the distributer is brand new

[00Civic]

maybe check for exposed or shorted wires? going to the ecu? just an idea

[Code-Aye]

^^
I cant even tel you how many times I have done that

[00Civic]

what about the plugs to the sensor? is it corroded?

[Barefoot]

put that jumper in