compression test

[james497]

Can you compression test a motor that is not in the car? If so how do i go about it. thanks!

[Black4DrEK]

you need a flywheel on it..

put the starter teeth into the teeth of the flywheel as if you were going to crank the engine up... put power to the starter.. it will turn the motor over.. check compression with your gauge

[james497]

ok thanks, just got a jdm b20b so i wondering how thanks again

[Barefoot]

i just turn it over by hand really fast

[james497]

i was think that would work but wasn't fosure

[Barefoot]

the best method would be a leak down. it still wont tell u the comp but shit atleast u know the cylinders are sealed.

[OldSchool87]

ok thanks, just got a jdm b20b so i wondering how thanks again

You didn't pay to much for that did you? You know its are carbon copy of the USDM B20Z right? anyways you should slap a GSR head on it:goodjob:
also if you turn it hand make sure you turn it with force or it will read real low if any

[Barefoot]

yah u got to own that bitch when u turn it.

[james497]

650 shipped

[james497]

i got a jdm b16a head for later down the road

[OldSchool87]

650 shipped
good price!

i got a jdm b16a head for later down the road
Nice. make a little money on the b20 head

yah u got to own that bitch when u turn it.
http://c2.ac-images.myspacecdn.com/images02/143/l_98346d1af2724a36abbce7b02174e1c1.jpg