View Full Version : 88 civic DOHC ZC help!
Black4DrEK
03-17-2010, 10:20 AM
I just did the dual point to Multi Point Conversion on the Car. Got a OBD0 to Obd1 ECU jumpere harness AND LS ECU.
It has a OBD1 dizzy that I hard wired in. And the Wires are correct.
The car NOW turns over and gets FUEL.. BUT does NOT get spark at all..
I have Double checked the wires 100 times:thinking: changed the Igniter out, New plugs, Wires, cap, ALL...
NO SPARK!?!?
I dont think there is a Fuse for this?
Please help ASAP, need the car running!:goodjob:
DustnU
03-17-2010, 07:26 PM
Hey guys PLEASE HELP!!!!!!!!!!!!
jdmpeez
03-17-2010, 08:26 PM
bump
gsrteg
03-17-2010, 08:37 PM
check all your groundings (bust out with your multi-meter) and see if the timing belt hasn't snapped...
jdmpeez
03-17-2010, 08:48 PM
timing belt new everything new on that hatch its either dizzy or wiring harness we checked all grounds
DustnU
03-22-2010, 09:24 PM
Bump!! Still not running!!
Barefoot
03-22-2010, 10:32 PM
was the dizzy known working before u installed it. known as in u seen it run not what the guy told u.
jdmpeez
03-23-2010, 08:40 AM
yes i saw the car run drove it and all that b4 i got the swap out of it. Now its in my car and wont run.. now fuel pump not cutting on and im still not getting spark..
solblu
03-24-2010, 04:56 PM
What OBD jumper harness are you using?
Will it run with a OBD0 ECU?
Black4DrEK
03-24-2010, 07:33 PM
^
Nope doesnt work with Obd0 ecu
Car was droped off at IMPORTEXPERTS!!!!
jdmpeez
03-25-2010, 08:13 AM
gona be on the road next week bustin hopefully
teggyslayer
04-01-2010, 10:11 AM
question? i was thinking of doing a zc swap in my ej1 coupe. can i use my dizzy from d15b7? will it bolt up to my dx tranny and use same clutch, flywheel, pressure plate? can i use the obd1 harness from my d15b7 i have and run the p06 ecu? if changes need to be made please inform me. I'd like to know whats what before i begin on the swap.
Black4DrEK
04-01-2010, 11:26 PM
^ Why do you want that swap in that car?
But..
Your tranny,clutch, flywheel,ect.. Will ALL work with the DOHC ZC.
Yes you can use the Obd1 harness...
Use a Obd1 Ecu that you are able to Chip/tune..
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.