All motor/ turbo build

[SRK420a]

Ok, so last October I melted my piston as you can see in pic 1. I decided to get a new block seen in pic 2. Not only that the block has been bored .40 over with is matched with a new crank, pistons, rods, and tranny..... mopar ECU, and a couple of essentials; new water pump, timing belt, pulleys, etc. comments appreciated and btw I'm building the motor to handle boost eventually, but for now here's my status.
Sorry for cell phone pics.....


FYI: Motor is a 420a, Eagle Talon ESi:idb:

[Supraboy87T]

If you're going turbo you should move this over to the turbo section. I would go with a 6 bolt swap instead of another 420a just my :2cents:. Good luck with the build.

[SRK420a]

If you're going turbo you should move this over to the turbo section. I would go with a 6 bolt swap instead of another 420a just my :2cents:. Good luck with the build.


Being different, but thanks for the input something is better than nothing:goodjob: