View Full Version : Quick ?- Bleeding Slave Cylinder (del Sol / b16)
Mr. Clean
02-28-2010, 08:47 AM
Bleeding the slave cylinder is no different than bleeding the brakes right?
Loosen, press clutch, tighten, release clutch - repeat. correct?
Barefoot
02-28-2010, 09:00 AM
correct
Mr. Clean
02-28-2010, 09:06 AM
gracias.
solblu
03-01-2010, 10:55 PM
I will not bleed very well that way. Best bet is to put a hose on it and run the hose into a half full bottle of fluid. Then fill the resevoir and pump the clutch slowly with the bleeder screw open.
...and don't give up... it takes a while sometimes :cheers:
Batlground
03-02-2010, 10:40 AM
That sounds correct, in theory.
Marta Mike
03-02-2010, 11:18 AM
I pump the clutch in between. Not just press. More like pump and hold
Barefoot
03-02-2010, 11:38 AM
i just reread it u got the order mixed up
tighten, press clutch, Loosen - repeat
Drummerboy
03-02-2010, 11:42 AM
I use a vaccuum bleeder, makes it SOOOO much easier.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.