View Full Version : wtb b20b or z
mitch lab
01-03-2010, 10:29 AM
Need b20b or z bottom end. lmk
youngmill
01-03-2010, 05:01 PM
I have a b20b bottom just pulled to change up on my set up. Block is in full may need rebuild But im just guessing on that statement. LMK
ACCORDPRIDE
01-03-2010, 05:06 PM
i have a fresh b20b bottom end that has been freshly gone through
*EFilliated*
01-04-2010, 07:08 PM
better yet it lost compression :goodjob:
I have a b20b bottom just pulled to change up on my set up. Block is in full may need rebuild But im just guessing on that statement. LMK
youngmill
01-04-2010, 08:30 PM
better yet it lost compression :goodjob:
THANK GOD! I just found out the block is good and I just bented the valves. Yeah buddy! We broke it down. the valves floated because my cams pushed them to low. BLOCK IS GOOD TO GO. LMK if u want this. Not you red EF, I was talking to the thread maker.
*EFilliated*
01-04-2010, 08:33 PM
:eek:
THANK GOD! I just found out the block is good and I just bented the valves. Yeah buddy! We broke it down. the valves floated because my cams pushed them to low. BLOCK IS GOOD TO GO. LMK if u want this. Not you red EF, I was talking to the thread maker.
youngmill
01-04-2010, 08:42 PM
:eek:
Its still good. I was just notified of it.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.