PDA

View Full Version : OBD-0 CRX check engine light



CB7tuner
12-05-2009, 08:06 AM
i just got this 90 CRX yesterday, it runs and drives fine but when i go over 70mph the check engine light comes on. it doesnt stay on, just when im at 70mph and above, its a stock d15 in it. how do i check the engine codes on this OBD-0 crx??? is it a jumper connector under the dash just like an OBD-1 car????

jdm_crx_man
12-05-2009, 08:28 AM
the ecu has a red light that flashes quick blinks=1 long blinks =10 ex. one long blink,one short blink =11 the google the cel number and it will tell what is wrong with the car...its very simple...gl




edit: here ya go......(the number represents number of flashes from the ecu error light)

Identifying the Fault Codes.

The number corresponds to the number of flashes.

1 Oxygen Sensor "A" (Primary) defective circuit or unplugged / defective sensor

2 Oxygen Sensor "B" defective circuit or unplugged / defective sensor

3 Manifold Absolute Pressure (MAP Sensor) defective circuit or unplugged / defective sensor

4 Crankshaft Angle Sensor (CAS) defective circuit or unplugged / defective sensor

5 Manifold Absolute Pressure (MAP Sensor) mechanical problem / disconnected piping

6 ECT Sensor (Engine Coolant Temperature) defective circuit or unplugged / defective sensor

7 Throttle Position Sensor (TPS) defective circuit or unplugged / defective sensor

8 TDC Position (Top Dead Centre Sensor) defective circuit or unplugged / defective sensor

9 CID Sensor (Number 1 Cylinder position) defective circuit or unplugged / defective sensor

10 IAT Sensor (Intake Air Temperature) defective circuit or unplugged / defective sensor

11 CO pot

12 EGR Lift Sensor (Exhaust Gas Recirculation) defective circuit or unplugged / defective sensor

13 APS Sensor (Atmospheric Pressure Sensor) defective circuit or unplugged / defective sensor

14 IAC/ISCV Valve (Idle Air Control/Idle Speed Control Valve) defective circuit or unplugged / defective sensor

15 Ignition Output Signal missing or defective ignition output signal

16 Fuel Injector System defective circuit or unplugged / defective fuel injector

17 VSS (Vehicle Speed Sensor) defective circuit or unplugged / defective sensor

18 Ignition Timing

19 Automatic Transmission Lock Up Control Solenoid Valve defective circuit or unplugged / defective solenoid valve

20 Electrical Load Detector (ELD)

21 VTEC Solenoid Valve defective circuit or unplugged / defective solenoid valve

22 VTEC Oil Pressure Switch defective circuit or unplugged / defective oil pressure switch

23 Knock Sensor (KS) defective circuit or unplugged / defective sensor

30 Automatic Transmission Signal: "A" / SEAF / SEFA / TMA or TMB

31 Automatic Transmission Signal "B"

41 Primary Oxygen Sensor – Heater circuit malfunction on D16Z6, D16Z7 and B16A2 engines

41 Linear Air Flow (LAF Sensor) heater malfunction on D15Z1 engine

43 Fuel Supply System defective or malfunctioning fuel supply system

45 System Too Lean or Too Rich malfunction in the fuel monitoring systems

48 Linear Air Flow (LAF Sensor) defective circuit or unplugged / defective sensor

54 CKF Sensor (Crankshaft Speed Fluctuation) defective circuit or unplugged / defective sensor

58 TDC Sensor 2 (Top Dead Centre) defective circuit or unplugged / defective sensor

61 Oxygen Sensor, Heated - Sensor 1 (Primary) high voltage, low voltage, or slow response

63 Oxygen Sensor, Heated - Sensor 2 (Secondary) high voltage, low voltage, or slow response

65 Oxygen Sensor Heater (Secondary) malfunctioning or defective oxygen sensor heater

67 Catalyst system Efficiency Below Threshold malfunctioning or defective catalyst system

70 Automatic Transmission malfunction with the automatic transmission controls

71 Cylinder 1 Misfire or a Random Misfire a condition is present that is creating a cylinder misfire

72 Cylinder 2 Misfire or a Random Misfire a condition is present that is creating a cylinder misfire

73 Cylinder 3 Misfire or a Random Misfire a condition is present that is creating a cylinder misfire

74 Cylinder 4 Misfire or a Random Misfire a condition is present that is creating a cylinder misfire

75 Cylinder 5 Misfire or a Random Misfire a condition is present that is creating a cylinder misfire

76 Cylinder 6 Misfire or a Random Misfire a condition is present that is creating a cylinder misfire

80 Exhaust Gas Recirculation insufficient flow detected

86 ECT Sensor (Engine Coolant Temperature) circuit range / performance problem

90 Evaporative Emission Control System leak detected in the fuel tank area

91 Fuel Tank Pressure Sensor low input.

92 Evaporative Emission Control System insufficient purge flow

SlamminCRX
12-05-2009, 02:32 PM
yea the obd0 ecu's have a light on the ecu itself, just gotta read the codes

silverDA
12-05-2009, 05:31 PM
non-obd:goodjob:

MidLifeCrisis
12-05-2009, 05:53 PM
non-obd:goodjob:

THANK YOU!! theres no such thing as OBD-0

southside
12-05-2009, 07:15 PM
THANK YOU!! theres no such thing as OBD-0You know what he meant though right?:thinking:Dont gotta be a asshole everybody doesnt know that its OBD0 and not OBD-0:goodjob:

punkr6
12-05-2009, 07:18 PM
You know what he meant though right?:thinking:Dont gotta be a asshole everybody doesnt know that its OBD0 and not OBD-0:goodjob:

x2, asshole

MidLifeCrisis
12-07-2009, 04:20 AM
You know what he meant though right?:thinking:Dont gotta be a asshole everybody doesnt know that its OBD0 and not OBD-0:goodjob:

You two are retarded, its not called OBD-0 or OBD0.. it was just called PGM-FI, OBD-I was the first time they used those letters.