1990 240sx with Fully Built SR20

[youngpre]

I just recently acquired this vehicle but due to some changes in my military orders out to California, I will not be able to take it with me. Note however, I am not in a major hurry to sell it, I received a very good deal on it and intend to pass that on to others but I have no intention of being ridiculously low-balled.

UNDER THE HOOD:
JDM SR20DET blacktop engine swap
JDM 25G (TD07) turbo
CP 8:8:1 Pistons
Eagle connecting rods
BR valve springs and retainers
BR in/ex valves
Circuit Sports rocker arm stoppers
Circuit Sports aluminum radiator reservoir
TOMEI 272 in/ex cams w/ 12.5mm lift
ARP head studs
Cometic 1.5mm head gasket
TIAL 44mm waste gate
TIAL 50mm blow off valve
Custom 304 SS turbo manifold
Custom 4in aluminum intercooler
Custom 3in aluminum intercooler piping
Custom SS vacuum lines
Custom SS air intake filter
Custom engine harness
Custom aluminum top feed fuel rail
Custom aluminum meth tank
Custom brake master cylinder heat shield
NOS intercooler nitrous fogger
NOS turbo single nitrous fogger
Samco radiator hose kit
Flexlite dual slim fan kit
NISMO oil cap
Chrome valve cover
Chrome intake manifold
KOYO aluminum radiator
Aeromotive fuel pressure regulator
Aeromotive #8 inline fuel filter
Top feed 1000cc injectors
Walbro 2 in-tank 255lph fuel pumps
ACT lightweight flywheel
ACT extreme sprung press. Plate
ACT 6 puck clutch disc
WHEELS/TIRES:
5Zigen FNO1R-C flat black 17X8.5 (f/r) wheels
Kuhmo Ecsta MX 235/45-17 (f/r) tires
SUSPENSION:
TEIN super drift coilovers (f/r)
TEIN strut tower bars
TIEN tie rod ends
BRAKES:
Enjuku slotted rear rotors
Enjuku SS brake lines
JDM brake master cylinder
EXTERIOR:
JDM 180SX front bumper
JDM 180SX rear bumper
JDM 180SX side skirts
JDM 180SX quarter panel glasses
JDM 180SX trunk spoiler
JDM 180SX taillights
Seibon CF vented bonnet
Apexi N1 full catback exhaust
INTERIOR:
Custom fiberglass door panels
Custom light grey rear seats
Custom red stitched black leather shift boot
B&M short shifter
ELECTRONICS:
AEM Standalone EMS
AEM UEGO 52mm wideband
AEM A/I temp. sensor
AEM 5bar map sensor
Defi 52mm blue racer boost gauge
Greddy profec-B boost controller
HKS turbo timer

I have the dyno sheet showing 450hp and a touch over 350 ft/lbs of torque.

Bout 10k on the rebuild or less and under 95k on the chassis

Retains a/c (wasn't cheap)
Runs very very well, no mechanical problems whatsoever but a new tune wouldn't hurt.
Only thing I'd change if I were keeping it, is that it's still a 4 lug
Lastly, I was told there is a 1.5way LSD in the rear end but have not checked. The previous seller's mechanic could not recall the brand however.

Thanks for looking and I'll start the price at $11,000 obo.

http://i40.photobucket.com/albums/e234/youngprernr/IMG_0553.jpg

http://i40.photobucket.com/albums/e234/youngprernr/IMG_0558.jpg

http://i40.photobucket.com/albums/e234/youngprernr/IMG_0560.jpg

http://i40.photobucket.com/albums/e234/youngprernr/photo.jpg

http://i40.photobucket.com/albums/e234/youngprernr/photo22.jpg

http://i40.photobucket.com/albums/e234/youngprernr/photo2.jpg

http://i40.photobucket.com/albums/e234/youngprernr/photo3.jpg

[jdm eg6]

bump for a nice s13

[Jonflip29]

Very nice S13. Too expensive for me tho. GLWS. What branch are you?

[tmracing83]

Damn! Glws man. The car is clean!

[E=MC²]

pm sent

[youngpre]

Air Force. Been in for 6 years at this point and just reenlisted for more fun haha

[youngpre]

I'll let it go this weekend for $9,500 picked up

[ljdmd]

What is the gas milage, mpg, on this car?

[Nick Jeezy]

damn, nicely done car.

i like the nitrous in the turbo.

good luck with selling the car.

[youngpre]

Gas mileage is as expected. Honestly though, I have no numbers for you as I haven't really followed it. You are able to daily it without getting into the boost much (big turbo making power up top) and get what seems to be decent mileage.

[FasTech]

Damn nice car, brosky. GLWS.

[youngpre]

$9,500 for 450hp. C'mon

[Franco Tirador]

nice price for a fully built engine

[youngpre]

^
Thanks

[bigeok]

Nice whip!

[youngpre]

Someone scoop it up and part it out. I would but I just don't have the space or time. Moving and whatnot

[E=MC²]

post dyno sheet

[youngpre]

I will get to a scanner at some point in the next 24 hrs.

[youngpre]

Still haven't made it to a scanner. Been getting slammed at work due to an upcoming TDY.

^up in the meantime

[E=MC²]

mine.

[veilside240]

if you go any lower then PM me

[youngpre]

Somebody come pick it up for $9,000 this weekend. If not, it's getting traded

[E=MC²]

still away peoples this is mine.

[m3th0d]

bump! gorgeous!

[youngpre]

Dyno sheet as many people have requested
http://i40.photobucket.com/albums/e234/youngprernr/scan0001-1.jpg

[dkjohnson04]

glws son! I vouch for this seller as it is my cousin and he is a very honest and upfront guy!

[youngpre]

Thanks man^


But

Close the thread. 350Z in the driveway, although the girl says not for long. Keep your eyes peeled for another FS ad in the near future.

[ljdmd]

congrats!

[tmracing83]

Want a clean ass 01 gsr??