PDA

View Full Version : multi point conv. last question


THEONE
10-02-2009, 04:58 PM
does anyone know of a diagram i can follow to just wire my obd0 si distributor straight without the plug,i dont care if you call it a hack job i need it done now and then i will wire it with a connector when i find 1. help :D
THEONE
10-02-2009, 08:39 PM
i just answered it, im gonna use my square plug of the 1.5 distributor and wire it to the 1.6 si distributor since the 5 colors match right up and then run the remaing 2 wires on the si distributor blue/green and blue/yellow to the c1 and c2 spot on the ecu :D i hope thats right
dallasb84
10-02-2009, 08:43 PM
are you any good at planting tulips?
.:Stirfry:.
10-02-2009, 08:54 PM
yea c1 goes to blu/g and c2 blu/y..
but which pin out on the ecu are you wireing up the injectors to.
THEONE
10-02-2009, 10:22 PM
yea c1 goes to blu/g and c2 blu/y..
but which pin out on the ecu are you wireing up the injectors to.

harness A 1,3,5,7 and the resistor box is at 15 on the same harness,the only issue im having is not having the si distributor connector so im gonna try and wire up the 1.5's square connectors to replace the round one.
THEONE
10-03-2009, 06:08 PM
what a waste of a day! put everthign in wired it all up and no start! i have a code8 on the ecu im thinking the distributor is bad,so i put all the multi point stuff back did everthing else in reverse ha! damn ebay!
Barefoot
10-03-2009, 06:17 PM
are you any good at planting tulips?semi funny the first time now old