PDA

View Full Version : HELP/? about raising adjustable coilovers



DOHC$MAN88
09-01-2009, 11:48 AM
Im trying to raise my car,but i've forgot the way to do it,The way im doing it is front then back.Abviously aint right bc when done,the front thrown off some.Go to raise the frt and i the back goes of

DOHC$MAN88
09-01-2009, 11:50 AM
any advice on how to do it to were they'll stay level?

eraser4g63
09-01-2009, 12:41 PM
side to side. I have always done the right then the left.

DOHC$MAN88
09-01-2009, 12:53 PM
Thanks ill try that

DOHC$MAN88
09-01-2009, 03:06 PM
ok,i tryed and failed.Im measuring from the ground to the fender's lip.
On the back of my civic i have skunk2 adj springs and on the front i have the actual skunk2 coilovers.

DOHC$MAN88
09-01-2009, 03:10 PM
Im going side to side but at the last wheel when i get it to measure up it throws of the opposite front wheel.
Any suggestions on how to start over from scratch again and how to go about it.

HeLLo iM iZzY
09-10-2009, 12:05 AM
You forgot how to raise a car? You don't just forget this over night.

holy shit....

Honda_91EF
09-10-2009, 04:07 PM
How do you have skunk2 adjustable springs and skunk2 adjustable coilovers?lol.

TypeRPersonality
09-12-2009, 09:45 PM
Count the number of full turns and apply it to each corner.

r_Senik
09-13-2009, 03:58 PM
take a marker, mark a line on the adjustable part. spin it, count it.
front to back or side to side.

Catnip
09-13-2009, 08:36 PM
I always took mine off, set them next to each other, and set them... THEN put them on the car. You probably have a bent subframe.

speedminded
09-13-2009, 08:39 PM
Am I really reading this right? :thinking: