Log in

View Full Version : need help



jdm_integra
08-21-2009, 08:05 PM
im new to the mustang world just purchased mine this sunday its a 1993 mustang lx 2.3l 4cyl 2 spark plugshttp://images.intellitxt.com/ast/adTypes/2.gif (http://mustangforums.com/forum/#) per cylinder just today it started to give me problems i was sitting in traffic when my rpm dropped to 500 and cel came on then when i try to go it wont let me rev past 3000 rpms does anyone knows what can be causing this and how can i fix it thanks

Barefoot
08-21-2009, 08:17 PM
pull codes report back


1. Ensure self test is DEACTIVATED, then START and run the engine at 2,000 rpm for two minutes. NOTE: IF the engine starts but stalls, or stalls during self test, refer to pinpoint test step S2. See: Pinpoint Tests\S - System Check\S2 - Check For RPM Drop
2. Turn the engine OFF and wait for ten seconds.
3. ACTIVATE the self test by grounding the STI connector.

Jumper Wire Installed Between Pin #2 And Self Test Input (STI)

http://img.photobucket.com/albums/v210/partsforsale/other/42295922.gif

4. Start the engine.
5. After the engine ID code, depress and release the brake pedal, then turn the steering wheel 1/2 turn and release it. If the vehicle is equipped with an E4OD transmission cycle the Overdrive Cancel Switch (OCS) .
6. When the dynamic response "goose" code appears, briefly go to wide open throttle.
7. Record all codes displayed. NOTE: Engine running service code 98/998 indicates vehicle is in Failure Mode Effects Management (FMEM) and DID NOT PASS the Key ON Engine OFF (KOEO) on demand/continuous memory self test. Engine running self test cannot be performed while in FMEM. Rerun KOEO self test and correct all fault codes. See: Key On Engine Off (KOEO) Self Test
8. Turn OFF the engine and DEACTIVATE the self test.
9. If a pass code (11) was received in the KOER test, proceed with the next step. See: Address Continuous Memory DTC If any other codes are received, refer to the proper diagnostic trouble code chart for the diagnostic path. See: Diagnostic Trouble Code Tests and Associated Procedures

jdm_integra
08-21-2009, 10:32 PM
thanks man ill try tomorrow