Headlight replacement 2007 Lexus IS 250

[Double_0_Rusty]

Sup guys, Ive got a 07 Lexus with factory HID's and one of them is out. I already have the new bulb. My question is, what all is involved? Tearing front end down? The dealership told her it would be over 400 bucks, and I am doing it on the side. How much would I charge for something like that. Any helpful hints/tips/advice will be rewarded with +14-15 reps. Thanks in advance.





-Rusty

[Barefoot]

400 what a rip off the book says .8 of an hour for low and high beam.

http://img.photobucket.com/albums/v210/partsforsale/other/135112466.gif
HIGH INTENSITY DISCHARGE HEADLIGHT BULB

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE ROOM SIDE COVER
http://img.photobucket.com/albums/v210/partsforsale/other/135112467.gif
4. REMOVE WASHER HOSE

1. Remove the bolt and washer hose.
http://img.photobucket.com/albums/v210/partsforsale/other/135112468.gif


REMOVE DISCHARGE HEADLIGHT BULB


Remove the headlight socket cover as shown in the illustration.
Remove the headlight gasket. NOTE: After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.



http://img.photobucket.com/albums/v210/partsforsale/other/135112469.gif

Separate the light control ECU socket as shown in the illustration.

http://img.photobucket.com/albums/v210/partsforsale/other/135112470.gif
4. Release the set spring and remove the discharge headlight bulb as shown in the illustration. NOTE: After the discharge headlight bulb is replaced, make sure that it comes on. Then, reinstall all the parts that were removed to replace the bulb.

INSTALLATION

1. INSTALL DISCHARGE HEADLIGHT BULB

1. Install the discharge headlight bulb. NOTE: After the discharge headlight bulb is replaced, make sure that it comes on. Then, reinstall all the parts that were removed to replace the bulb.
2. Install a new headlight gasket. NOTE: After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
http://img.photobucket.com/albums/v210/partsforsale/other/135112471.gif
2. INSTALL WASHER HOSE

1. Install the washer hose with the bolt. Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

3. INSTALL ENGINE ROOM SIDE COVER
4. INSTALL COOL AIR INTAKE DUCT SEAL
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION Some systems need initialization after reconnecting the cable to the negative battery terminal.

[Double_0_Rusty]

'preciate it hoss!

[Barefoot]

np

[97_c1vic]

Wtf? Over $400 just for that? Damn what a rip off...

[Barefoot]

Wtf? Over $400 just for that? Damn what a rip off...if i could charge those prices id do 2 headlights a week and be happy. 3 if i got bored.