PDA

View Full Version : Power Mods lsvtec Question?


8ball
08-19-2009, 05:14 PM
info>>>>


96 gsr head
B18A1 block
pr3 pistons
ls tranny


recently bought a car at the auction with this setup in it.
how many hp will this setup make? (cuz it pushes pretty good in a crx)
88NaCivic
08-19-2009, 05:49 PM
Dyno knows all
And if you bought it at auction how do you know what kind of pistons are in it ??
allmotorX
08-19-2009, 05:52 PM
Dyno knows all
And if you bought it at auction how do you know what kind of pistons are in it ??x2 and you should get a shorter geared tranny it will pull alot better
8ball
08-19-2009, 05:54 PM
i broke it down already...it looks clean.
head looks like it has new springs and retainers looks like sum1 shaved it a bit too.
but the wiring is ugly home made kinda,might need sum help with that too.
8ball
08-19-2009, 05:56 PM
x2 and you should get a shorter geared tranny it will pull alot better

wut kinda tranny?
88NaCivic
08-19-2009, 06:05 PM
Where are you located?
8ball
08-19-2009, 06:18 PM
Where are you located?

gwinnett whi?
88NaCivic
08-19-2009, 06:25 PM
I also have a EF. wiring is fun
8ball
08-19-2009, 06:28 PM
do u do wiring cuz my shit looks ugly but it works...
trying to go obd1
88NaCivic
08-19-2009, 06:30 PM
I can but dont like to.
allmotorX
08-19-2009, 06:58 PM
wut kinda tranny?Either b16, gsr, or type r tranny
8ball
08-19-2009, 07:10 PM
any1 familiar with this engine setup....
does it have potential?
Barefoot
08-19-2009, 08:00 PM
any1 familiar with this engine setup....
does it have potential?its a pretty common setup. if built right its the equal of a gsr. without getting all technical.
Turbodude06
08-20-2009, 09:25 AM
wut kinda tranny?

Trans:

LS-:jerkit:
GSR-If u drive a lot of highways and stuff
B16/ITR-If u don't lol:lmfao: shorter then the GSR, but suck on the highways
Formally...
08-20-2009, 11:53 AM
This is a pretty high compression setup. Have you pulled the oil pan yet to see if it has aftermarket rods or at least arp rod bolts. You will need some pretty good cams to make some power with this compression. Also, let me know if you need help with the wiring (I am the ef master :D )
8ball
08-20-2009, 12:38 PM
how can i tell wut kind of cams my gsr head has..?
is there a way to find out a # or letter o sumthin?
BABY J
08-20-2009, 12:40 PM
This is a pretty high compression setup. Have you pulled the oil pan yet to see if it has aftermarket rods or at least arp rod bolts. You will need some pretty good cams to make some power with this compression. Also, let me know if you need help with the wiring (I am the ef master :D )

Showoff.