B16a in limp mode?

[rsxappeal]

Alright, help me out please. I havent checked the codes yet, bout to when i get home. In the meantime, just finished 93 b16a in 97 hatch. It has a rywire harness that converts from the engine to obd2a. I tried to plug my single cam obd2a ecu in it after i finshed the swap. It started up and idled perfect, but cant rev it past 2-3k(no tach to really know). I'm guessing it is in limp mode, but why? because im using a single cam ecu on a jdm b16? help please

[.:Stirfry:.]

switch the map and tps.. done

[wrekonize]

viagra will keep it from going limp... put it in your tank....

[Tech5]

Check your Vtec Fluid I here KY works great in it also!

[rsxappeal]

^nice, but no. So your sayin put my single cam map and tps on the b16?

[Tech5]

^nice, but no. So your sayin put my single cam map and tps on the b16?

It will not fix that, either they are crossed up !

But you need to scan it for codes!

[.:Stirfry:.]

^nice, but no. So your sayin put my single cam map and tps on the b16?

no, you may have your tps on your map and map on tps

[CaTcH22]

^nice, but no. So your sayin put my single cam map and tps on the b16?You's prolly gots crossed up wires. Its easy to do, they are the same plug.

[rsxappeal]

No they arent crossed. I got codes for rear o2 sensor and idle air control(or bad ecm) and thats it. i think its just in limp mode from using the d16 ecu on a b16

[CaTcH22]

No they arent crossed. I got codes for rear o2 sensor and idle air control(or bad ecm) and thats it. i think its just in limp mode from using the d16 ecu on a b16UHH.... thats a pretty serious one!! I think you might wanna start there.

[rsxappeal]

fixed it w/ a p28 and fixed wrong sensor plugged into iacv