PDA

View Full Version : need a quote...



91crxsi
03-25-2005, 09:35 AM
i need a price quote for install + labor charges on these engines...

ZC DOHC
1st Gen B16

LMK

A.P. Photography
03-25-2005, 10:23 AM
I am going to guess that you are installing this in the CRX Si?

Vteckidd
03-25-2005, 11:07 AM
CRX SI
SRZ charges

ZC $500
B16 $750

91crxsi
03-25-2005, 09:32 PM
actually its a dx.i know my screenname says si but i let a dumbass create my s/n... but sorry let me rephrase my title.i was in a hurry last nite.

how much for you to get the motor,install it,and how much for labor.

91crxsi
03-26-2005, 01:02 AM
im more then likely getting one of these swaps mid april

Vteckidd
03-26-2005, 12:58 PM
ok well, your going to need a few things, heres the rundown

1) motor mounts for a B16 swap $400
2) Linkage-$80
3) B16 OBD0 Swap-$1400
4) Hubs an knuckles for SI ($100)
5) labor $700

wannab20hatch
03-26-2005, 02:57 PM
Dont run si knuckles just get some DA (90-93) integra front hubs and youll have bigger brakes up front.

91crxsi
03-26-2005, 06:06 PM
ok now how bout the ZC?

88civiczc
03-27-2005, 02:38 AM
ZC:
Change your wiring alot actually for DX.
use your stock mounts and tranny and axles and hubs and shift linkage.
ZC itself: Ive seen varying prices depending where you go...$450-$600
whole swap Engine, transmission, halfshaft, and ecu like $850
and just run 90-91 Teg axles with the ZC trans.

91crxsi
03-27-2005, 05:22 PM
so im looking at around 1200-1400 total including labor? or more

91crxsi
03-27-2005, 05:24 PM
btw this is a shell...its all stock.not sure if the tranny on it is any good.

Vteckidd
03-28-2005, 08:46 AM
ZC swaps run $700-800

Labor is $500

91crxsi
03-31-2005, 11:44 PM
also im not wanting any internal work done in the future. done seen to many good rides go dead 1 week after rebuilds so ya know...what bolt ons are there for the b16