PDA

View Full Version : !Help before i set fire to it!



sncracing1
07-03-2009, 02:49 PM
Ok i have a 92 civic hatch cx...i just dropped a ls/vtec in it monday.......ive had a some small issues that ive fixed but ive got one that i cant put my finger on. The motor runs fine 90% of the time but every once and a while when you take of from a dead stop AND while riding down(cruising not raising hell) the road it surges like im loosing power or something. Ive checked all my vacuum hoses but don't really know where else to look...any advice?

SUBY_RUE
07-03-2009, 02:59 PM
Did you replace the plugs, wires, cap and button? I had the same problem before, and found moisture in the spark plug gallys.

sncracing1
07-03-2009, 03:03 PM
yea its all brand new....it has new everything...pistons rods cams bearings valvesprings etc...the whole nine yards i put new cap button wires everything....thats why it's pissing me off so bad...and every once and a while it will do it so hard when i go to take off that it will shut off the car....

VickNotic
07-03-2009, 03:04 PM
this might be my problem as well.. 8D

sncracing1
07-03-2009, 03:06 PM
this might be my problem as well.. 8D

well i hope we both figure it out....

SUBY_RUE
07-03-2009, 03:08 PM
What ecu are you using? have you checked the fuel filter lately?

sncracing1
07-03-2009, 03:13 PM
What ecu are you using? have you checked the fuel filter lately?

im running a chipped p28 that i done my own little street tune using the chrome program and a wideband o2 lol and never had this problem before...and its a new fuel filter as well....keep guessing ill take anything into consideration! thanks for the hlep

SUBY_RUE
07-03-2009, 04:30 PM
Im running out of ideas, other than checking the map sensor or idle air sensor...

scttydb411
07-03-2009, 05:17 PM
any cel? since you're doing some tuning using crome, why not just do some datalogging and drive around...it may point you in the right direction, or it may not.

speedminded
07-03-2009, 05:30 PM
OEM plug wires? What spark plugs, not platinum are they?

sncracing1
07-04-2009, 01:12 AM
any cel? since you're doing some tuning using crome, why not just do some datalogging and drive around...it may point you in the right direction, or it may not.

no cels at all and my buddy has my laptop and widband but he is coming into town tomorrow so thats my next option but its really annoying during the wait...say i drive the car 30 times in a day it will only do it like 3 out of those 30

sncracing1
07-04-2009, 01:13 AM
OEM plug wires? What spark plugs, not platinum are they?

Im running some OBX 10mm wires and just some ngk plugs not platinum..

sncracing1
07-04-2009, 01:22 AM
any way it could be the tps or something...or is there a easy way to check it?

speedminded
07-04-2009, 01:36 AM
Im running some OBX 10mm wires and just some ngk plugs not platinum..Put OEM Honda on.

Catnip
07-04-2009, 01:40 AM
Try a different ignition module and OEM plug wires.

Catnip
07-04-2009, 01:43 AM
What I meant to say was, it's a bad motor, sell it to me... for cheap :)

sncracing1
07-04-2009, 01:50 AM
What I meant to say was, it's a bad motor, sell it to me... for cheap :)

:cheers: i hear ya pimpin...lol i wish i could.....ill try new wires tomorrow the only reason i didnt figure it would be that is because it dont skip or run ruff or anything it just surges something aweful

speedminded
07-04-2009, 01:52 AM
:cheers: i hear ya pimpin...lol i wish i could.....ill try new wires tomorrow the only reason i didnt figure it would be that is because it dont skip or run ruff or anything it just surges something awefulCompression test? :doh: You have a fuel pressure gauge on it?

sncracing1
07-04-2009, 02:07 AM
Compression test? :doh: You have a fuel pressure gauge on it?

yea ive done a compression test about 4 times i get between 170 to 180 across the board....keep in mind its got 9:1 compression pistons in it so its a little low but i dont have a guage on it but i did buy on earlier i just gotta put it on in the mornin...

jdmda9
07-06-2009, 11:27 AM
check ur pcv valve and make sure its properly hooked up all the way to the box thats on the back of the block...or check ur dizzy? timing...? just throwing out suggestions...i hate it when you have these type of problems...it seems like their impossible to fix...but i hope you find out what it is soon bro! GL