View Full Version : h22 in cb7 problems
Big_Joe
06-24-2009, 03:33 PM
Ok i swapped my H22 into my 91 Accord. It turns on and drives but the problem is it won't rev past 3500 RPM. I tried switching ECUs and it still did the same thing. Does anyone have an idea what the problem is?
HatchHero
06-24-2009, 04:01 PM
check engine light on?? sounds like tps, is it plugged up? u might have the tps and map backwards
D3UC3S
06-24-2009, 04:11 PM
check the VSS.....that will make it do the same
HatchHero
06-24-2009, 04:24 PM
what codes are u throwin? code 17 is vss i think, what ecu you runnin? p13? if you changed it out with known GOOD ecu i dont think its vss i think you plugged something up wrong.. how and where did you run those vtec wires to which pinout??
Big_Joe
06-24-2009, 05:05 PM
I changed my ecu to the p13 ecu. And yes the check engine light is on.
SilverSurfer
06-24-2009, 05:17 PM
are u using the f series wire harness or the h series one
edit: cb7tuner.com can probably help you out too
D3UC3S
06-24-2009, 05:21 PM
I changed my ecu to the p13 ecu. And yes the check engine light is on.
whats the code broseph????
Big_Joe
06-24-2009, 05:31 PM
I'm using the F series wiring harness. and i haven't went to check what codes is it giving.
whatever210
06-24-2009, 06:55 PM
go check codes. ur in the dark without knowing. and the f22 wiring harnest fine. u have to run knock sensor and vtec solinoid wire
HatchHero
06-24-2009, 07:37 PM
bring bak codes just jump the pigtail and count
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.