1NonlyAccord
05-31-2009, 11:01 AM
Just got a cheap 90amp flux welder to do some exhaust work and small around the house projects.
I know its not the best,or the welds wont look good. But it will be wrapped in heatwrap,so not concerned.
Will it hold up to the exhaust temps? for Turbo Downpipe and exhaust itself?
info on it.
# Input: 115 volt, 15 amp, single phase
# Welding current (2 settings) 63 to 68 amps (low), 79 to 90 amps (high)
# Duty cycle: 10% @ 80 amps, 18% @ 60 amps
I know its not the best,or the welds wont look good. But it will be wrapped in heatwrap,so not concerned.
Will it hold up to the exhaust temps? for Turbo Downpipe and exhaust itself?
info on it.
# Input: 115 volt, 15 amp, single phase
# Welding current (2 settings) 63 to 68 amps (low), 79 to 90 amps (high)
# Duty cycle: 10% @ 80 amps, 18% @ 60 amps