View Full Version : Brake Piston Compresoor Tool
phuoc_dat
03-21-2009, 10:30 PM
So i tried to compress my rear integra brake piston in an attempt to change out my brake pads and it wont turn. I have tried the plier technique but i believe my piston might be seized. Is there a specific tool that is needed to compress the piston that i might not know of? If there is, can someone please tell me how it looks like and where to purchase it?
Thanks.
03RCode
03-21-2009, 10:31 PM
There is a caliper squeezer made for that, but if you don't have one try a decent sized C clamp.
phuoc_dat
03-21-2009, 10:39 PM
the rear has to be turned in so i dont think c clamp works..
03RCode
03-21-2009, 10:41 PM
Ah, my bad. Not very up to date with my Honda's, and didn't exactly completely read your whole post.
phuoc_dat
03-21-2009, 10:43 PM
thanks thougt. Repp +
Barefoot
03-22-2009, 12:50 AM
u need this
http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=80332&group_ID=1682&store=snapon-store&dir=catalog
but a cheaper route is this
http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=66110&group_ID=1682&store=snapon-store&dir=catalog
xlilvi3tx
03-22-2009, 02:54 AM
only the front brakes need to be compressed for the integra. the rear has this cross looking thing that u need to turn. u can either use a big flathead or the proper tool
jdm eg99
03-22-2009, 03:45 AM
^ i agree
phuoc_dat
03-22-2009, 12:14 PM
thanks all, i just bought the cube.
Barefoot
03-22-2009, 03:35 PM
thanks all, i just bought the cube.:D;):goodjob:
phuoc_dat
03-22-2009, 06:36 PM
Cube doesnt seem to work. My piston is too far out, not giving the cube enough clearance to be inserted inside the caliper. I think my caliper piston is seized.
Barefoot
03-22-2009, 11:28 PM
a big ass per of channel locks and a clamp. turn and compress at the same time.
phuoc_dat
03-23-2009, 01:12 PM
i just bought some new used caliper. Thanks for your help man. repp
Barefoot
03-23-2009, 03:05 PM
np
Harbor freight and buy the piston caliper tool only like 20-30$ I was there the other day.. or just go to autozone and rent it
Barefoot
03-24-2009, 07:22 AM
i just bought some new used caliper. Thanks for your help man. repp
Harbor freight and buy the piston caliper tool only like 20-30$ I was there the other day.. or just go to autozone and rent itto late
itsalive
03-25-2009, 09:04 PM
Just use a large screw driver, lay flat into the cross section and turn that piston. ;)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.