View Full Version : Power Mods i need help
weaver89
03-13-2009, 11:03 PM
were is the intake air temperature sensor located on a d16z6. thanks reps for help.
jellybean
03-13-2009, 11:29 PM
were is the intake air temperature sensor located on a d16z6. thanks reps for help.
hope this helps...:-) here is the site http://raptor-tech.com/Documents/diagrams.pdf
http://i174.photobucket.com/albums/w109/jjjellybean/Other%20Stuff/enginepic3.jpg
weaver89
03-13-2009, 11:34 PM
thanks it does help i some ppl tell me they never heard of them going bad so. can it be cleaned or is there something else causing the problem
jellybean
03-13-2009, 11:39 PM
thanks it does help i some ppl tell me they never heard of them going bad so. can it be cleaned or is there something else causing the problem
sorry... can't help with that one..... but you can try searching the internet...:-)
weaver89
03-13-2009, 11:43 PM
ok thanks man
jellybean
03-14-2009, 06:51 AM
I was doing some thinking... and i know that can be dangerous sometimes...lol... but i would think that it can be cleaned and tested.. just don't know what resistance level to test it at... and as far as the cleaning goes.. it should just be a little scotch brite ... i would check on the internet for any testing method for it... you might just get lucky../:-)
Scotsman
03-14-2009, 08:17 AM
ok thanks manlol , the "man" is a maam
jellybean
03-15-2009, 08:56 AM
lol , the "man" is a maam
lol...:-)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.