Question About a D-series Setup..

[Romeo]

Well after finding the broken rod, I noticed that it also spun 2 bearings on the crank. I have a D15B2 sitting in my garage for a while now. I was thinking of just swapping in the bottom end from that motor with the Jdm ZC head ontop of it. I was thinking it could be some kinda "Mini me" setup. I was wondering what would be the better setup, in your opinions.
Option A: Rebuild the ZC block.
Or Option B: Swap in the D15B2 bottom end.

[J-ROCK]

idk man i say swap in the d15

[punkr6]

The zc would be better because its a 1.6, You need to get the crank checked and see if its rebuildable...

[Romeo]

The zc would be better because its a 1.6, You need to get the crank checked and see if its rebuildable...
That's what i'll be doing once i get the rest of the block apart. I'm going to bring the block and crank to have them checked out.

[punkr6]

That's what i'll be doing once i get the rest of the block apart. I'm going to bring the block and crank to have them checked out.

sounds like your on top of it..G/L

[Romeo]

sounds like your on top of it..G/L
Thanks. It's just the way how that rod was in there scares me. I'm hoping everything is good to go.

[AnthonyF]

Swap out the d15 and see how you like it. It's not all that difficult and would be a fun swap to do.

-Ant.

[Barefoot]

d15b

[£G2♣]

i would say go with option b

[Master Shake]

option b, you could use it for the time being, and give you time to build the other bottom end.