-S Double C-
02-14-2009, 12:52 AM
I have a set of NEW D-series 9:1 SRP Standard bore pistons with Scat H-beam Rods with ARP 2000 rod bolts and a set ACL Race main bearings and rod bearings that are new too. Price is 560 for all of this together.
SOLD!!
Next up is D series Eldebrock Performer X Intake manifold with the extra 4 injectors and eldebrock fuel rail. I didnt run the extra 4 injectors cause my 1000cc's were plenty. Price is 240.
Next is a D16Z6 head that was built by JG Engine Dynamics. I made 511whp on this head at 29.5psi. The head was Ported and Polished on the intake and exhaust side and the work is flawless, it also recieved a 5 angle valve job, the bowls were slightly enlargened and polished along with bronze valve guides and new seals installed. It has new skunk 2 Springs and retainers with a ZEX 59500 Cam and a AEM 3 bolt cam gear. I used the head for around 4k as well and then took it off and had a local machine shop clean it up and resurface it so it is ready to bolt on for the next buyer. I have around 1600 in the head and looking to get 800 for it. Or will do a package price of the head and intake manifold for 1000.
SOLD!!
I dont have any use for these parts anymore. I have 4 cars and too many parts here and there. I was gonna use the head for my beater but im already making 360whp on the stock head and it is plenty quick till i finish my drag car.
SOLD!!
Next up is D series Eldebrock Performer X Intake manifold with the extra 4 injectors and eldebrock fuel rail. I didnt run the extra 4 injectors cause my 1000cc's were plenty. Price is 240.
Next is a D16Z6 head that was built by JG Engine Dynamics. I made 511whp on this head at 29.5psi. The head was Ported and Polished on the intake and exhaust side and the work is flawless, it also recieved a 5 angle valve job, the bowls were slightly enlargened and polished along with bronze valve guides and new seals installed. It has new skunk 2 Springs and retainers with a ZEX 59500 Cam and a AEM 3 bolt cam gear. I used the head for around 4k as well and then took it off and had a local machine shop clean it up and resurface it so it is ready to bolt on for the next buyer. I have around 1600 in the head and looking to get 800 for it. Or will do a package price of the head and intake manifold for 1000.
SOLD!!
I dont have any use for these parts anymore. I have 4 cars and too many parts here and there. I was gonna use the head for my beater but im already making 360whp on the stock head and it is plenty quick till i finish my drag car.