SCAT rods not fitting in the cylinder bore???

[Mad Mike]

Like the the title states my SCAT rods wont slide inside the cylinder bore. They will go in buts its really tight and I don't want to scratch the bore. Its a d16Z6 stock bore with just honing done.

Would it be ok to sand down the edges of the rods just enough to get them to freely slide down the bore?
http://i123.photobucket.com/albums/o288/cordiaturboowner/other/scat1.jpg

Thanks for any info.

[redfire6i]

you have to notch the block when you put H beams in. Check out d-series.org or turbod16.com for how-to's.

[Mad Mike]

I know about the notching. I can't get the rods in the bore to get them down to the crank to see where and how much to notch. There to wide to freely slide down the stock piston bore.

[redfire6i]

Oh I see what your saying...my bad. I have Eagle rods in mine and they just slid right in. I remember it being a tight fit though. :thinking:

[Mad Mike]

yea its tight but its scratching the bore so its to tight. Hummmm

[Init2winit]

How much material do you need to remove? That will be fine to remove some from there, but not a whole lot.

[-S Double C-]

its normal just slide them on down in there its a tight fit mine did the same thing. I promise you it wont hurt the bore or anything i made 511whp afterwards so its good and ive built 3 d series.

[Mad Mike]

Ok problem solved I sanded them down just enough to get them to fit.

Thanks for the info.